Dream Pico Port Settings

This page allows you to communicate with a Dream Pico Port device to change settings and read/write VMU data over the WebUSB API.
Version 1.2.0 of firmware or later must be loaded for this page to work.
Ensure flycast is not running while attempting to activate functions on this page
See Dream Pico Port GitHub page.

Click Select Device to provide this page permissions to access a Dream Pico Port device

Enable Mass Storage Class

WebUSB Announcement

D-PAD output:

Controller A:

Controller B:

Controller C:

Controller D:

Controller Detection Types:

Disabled:	Always disable USB gamepad and all controller communication
Enabled:	Always enable USB gamepad and controller detection/communication
Disabled, Enable On Detect:	Disable USB gamepad on power up, listen for controller, switch to Enabled and save on detection
Auto:	Automatically enable USB gamepad once detected and disable once removed
Auto, No Disable:	Automatically enable USB gamepad once detected, don't disable until power loss

Take note that the entire USB interface needs to be refreshed in order to change the number of controllers available to the host system over USB. You will experience interruptions in communication during these operations.

Controller A	Controller B	Controller C	Controller D
VMU1	VMU1	VMU1	VMU1
VMU2	VMU2	VMU2	VMU2

WARNING: Do not change these settings unless you know what you are doing!

Damage to the GPIO may occur if these settings don't match your hardware configuration.

Controller A GPIO Values	Controller B GPIO Values	Controller C GPIO Values	Controller D GPIO Values
SDCK-A:	SDCK-A:	SDCK-A:	SDCK-A:
SDCK-B: 11	SDCK-B: 13	SDCK-B: 19	SDCK-B: 21
DIR:	DIR:	DIR:	DIR:
DIR Output HIGH	DIR Output HIGH	DIR Output HIGH	DIR Output HIGH

LED*: Simple LED*:

For any GPIO setting, leave blank to disable.

*Simple LED stays on when USB connected and turns off when disconnected. The normal LED setting also reacts to button presses on any connected controller.